how to clean microsoft wireless mouse 3500

By loosening the two screws at the front, it relieved some pressure and let it run more smoothly. I will say that my sticky scroll wheel was scraping against the upper shell. I didn't take any of the inner parts apart after that. This will take a little bit of prying since it's all clipped together, but it will come loose. There is a little piece of circuit board that sticks out underneath the right-click area that will get hung up on the upper shell if you try to pull it straight down. You need to pull the bottom of it free at the back and then slide the entire bottom section back. It's just held on by a couple of little nubs. Use a flathead screwdriver to pry the retainer clip from the back of the mouse. The clips up at the front go in a forward direction, but they are not clipped in. Remove that and then lift the gray upper section up from the back, then pull it free by moving it toward the back. Leave the other (the one under your fingertips) alone.Ģ. Peel up the teflon pad on the bottom of the mouse with a flat head screwdriver. You need a set of precision screwdrivers to do this.ġ. I disassembled my Microsoft Wireless Mobile Mouse 4000.

How to clean microsoft wireless mouse 3500